This is a working overview of aliquoting, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2025-08-12 and is reviewed periodically as new material appears.
When a peptide arrives, the vial should be inspected for damage, and its label, lot number, and accompanying analytical data should be recorded. Cold vials should equilibrate to room temperature before opening to prevent condensation on the powder. Moisture uptake can reduce stability and complicate accurate weighing or reconstitution. Inventory systems that track date, quantity, and storage location help prevent unnecessary temperature cycling. Personnel should follow institutional or manufacturer instructions for any specific peptide.
Reconstitution is often performed with sterile water, buffer, or a water-miscible organic solvent, depending on solubility. The solvent should be added gently along the vial wall, and the solution mixed by gentle swirling rather than vigorous vortexing, which can cause foaming and surface denaturation. Some sequences require a small amount of base or acid to dissolve, followed by pH adjustment. Preparing a concentrated stock solution can simplify later dilution, but the stock itself may have limited stability. Records of solvent, concentration, and date support reproducibility.
Peptides are short chains of amino acids linked by amide bonds, and their storage stability depends on sequence, length, and three-dimensional structure. Chemical degradation can occur through hydrolysis, oxidation, deamidation, and aggregation, while physical changes such as precipitation or surface adsorption reduce recovery. Storage conditions are chosen to slow these processes without altering the peptide itself. Because peptides vary widely, no single condition suits every sequence, so laboratories often establish stability empirically for each batch.
Temperature is a primary factor because most degradation reactions proceed more slowly at lower temperatures. Lyophilized peptides are commonly held at -20 °C or below, although some sequences remain stable at 2–8 °C for limited periods. Moisture uptake during handling can accelerate hydrolysis, so sealed containers and desiccants are used. Solutions are generally less stable than powders and may require freezing at -80 °C or refrigeration, depending on the peptide. Repeated freeze-thaw cycles can promote aggregation even when the storage temperature is otherwise suitable.
| Property | Value | Notes |
|---|---|---|
| Container material | Type I borosilicate glass or polypropylene | Low peptide adsorption; avoid untreated polystyrene for dilute solutions. |
| Headspace gas | Nitrogen or argon | Inert gas reduces oxidation for methionine- or cysteine-containing peptides. |
| Light exposure | Amber vial or foil wrap | Limits photodegradation of tryptophan, tyrosine, and phenylalanine residues. |
| Reconstitution solvent | Water, buffer, or water-miscible organic solvent | Choice depends on sequence charge and hydrophobicity; use highest available purity. |
| Aliquot size | Single-use portions | Minimizes warming and cooling cycles and cross-contamination between uses. |
British endocrinologist Albert T. W. Simeons proposed HCG as an adjunct to an ultra-low-calorie weight-loss diet (fewer than 500 calories). Simeons, while studying pregnant women in India on a calorie-deficient diet, and obese boys with pituitary issues (Frölich's syndrome) treated with low-dose HCG, observed that both lost fat rather than lean (muscle) tissue. He reasoned that HCG must be programming the hypothalamus to do this in the former cases in order to protect the developing fetus by promoting mobilization and consumption of abnormal, excessive adipose deposits. Simeons in 1954 published a book entitled Pounds and Inches, designed to combat obesity. Simeons, practicing at Salvator Mundi International Hospital in Rome, Italy, recommended low-dose daily HCG injections (125 IU) in combination with a customized ultra-low-calorie (500 cal/day, high-protein, low-carbohydrate/fat) diet, which was supposed to result in a loss of adipose tissue without loss of lean tissue. Other researchers did not find the same results when attempting experiments to confirm Simeons' conclusions, and in 1976 in response to complaints the FDA required Simeons and others to include the following disclaimer on all advertisements:
The main etiologic factor of ACC is unknown, although families with Li–Fraumeni syndrome, caused by an inherited inactivation mutation in TP53, have increased risk. Several genes have been shown to be recurrently mutated, including TP53, CTNNB1, MEN1, PRKAR1A, RPL22, and DAXX. The telomerase gene TERT is often amplified while ZNRF3 and CDKN2A are often homozygously deleted. The genes h19, insulin-like growth factor II (IGF-II), and p57kip2 are important for fetal growth and development. They are located on chromosome 11p. Expression of the h19 gene is markedly reduced in both nonfunctioning and functioning adrenal cortical carcinomas, especially in tumors producing cortisol and aldosterone. Also, a loss occurs of activity of the p57kip2 gene product in virilizing adenomas and adrenal cortical carcinomas. In contrast, IGF-II gene expression has been shown to be high in adrenal cortical carcinomas. Finally, c-myc gene expression is relatively high in neoplasms, and it is often linked to poor prognosis. Bilateral adrenocortical tumors are less common than unilateral. The majority of bilateral tumours can be distinguished according to size and aspect of the nodules: primary pigmented nodular adrenocortical disease, which can be sporadic or part of Carney complex, and primary bilateral macro nodular adrenal hyperplasia.Metastasis is most commonly to the liver and lung.
AlphaFold's predicted structures are widely used in biological research, though the precise scale of that use is difficult to measure. More than 40% of protein-structure papers published in 2023 in Cell, Nature, and Science cited AlphaFold 2. A 2024 bibliometric analysis of the Web of Science database identified 1,680 peer-reviewed papers referencing AlphaFold published between January 2019 and May 2024. Measures of this kind rely on authors citing the AlphaFold papers when they use the tool, a convention encouraged but not enforced by the maintainers of the AlphaFold Protein Structure Database. Attempts to validate these counts against the full text of papers suggest that citations to foundational AlphaFold papers can both overstate and understate how widely the tool is used. In an analysis of about 8,900 papers in the PubMed Central Open Access corpus that mentioned AlphaFold, roughly 30% cited none of three foundational AlphaFold papers, while only about half of the papers citing at least one of those three mentioned AlphaFold anywhere in their text. A smaller manual check of 100 papers from a curated protein-literature database found a similar shortfall, with fewer than half of those mentioning AlphaFold including a formal citation.
Sources: en.wikipedia.org
Different active sites are bonded by agonist and antagonist, which means the antagonist obstructs the chain of events that triggers the agonist to produce a response at a point downstream from the agonist binding site on the receptor. It irreversibly binds to the active site. One examples is when Ketamine enters the NMDA receptor's ion channel pore and blocks it, stopping ions from passing through the channels. Also, medication like nifedipine and verapamil stops Ca2+ from entering the cell membrane and so non-selectively prevent medications that act at any receptor that binds to these calcium channels from causing smooth muscle contraction.
Topical analgesia is generally recommended to avoid systemic side-effects. Painful joints, for example, may be treated with an ibuprofen- or diclofenac-containing gel (The labeling for topical diclofenac has been updated to warn about drug-induced hepatotoxicity.); capsaicin also is used topically. Lidocaine, an anesthetic, and steroids may be injected into joints for longer-term pain relief. Lidocaine is also used for painful mouth sores and to numb areas for dental work and minor medical procedures. In February 2007 the FDA notified consumers and healthcare professionals of the potential hazards of topical anesthetics entering the bloodstream when applied in large doses to the skin without medical supervision. These topical anesthetics contain anesthetic drugs such as lidocaine, tetracaine, benzocaine, and prilocaine in a cream, ointment, or gel.
In molecular biology, the BtpA protein family is a family of proteins which includes BtpA. BtpA appears to play a role in the stabilisation of photosystem I. It is an extrinsic membrane protein located on the cytoplasmic side of the thylakoid membrane. Homologs of BtpA are found in the Thermoproteota and "Euryarchaeota", where their function remains unknown. The Ycf4 protein is firmly associated with the thylakoid membrane, presumably through a transmembrane domain. Ycf4 co-fractionates with a protein complex larger than PSI upon sucrose density gradient centrifugation of solubilised thylakoids. The Ycf3 protein is loosely associated with the thylakoid membrane and can be released from the membrane with sodium carbonate. This suggests that Ycf3 is not part of a stable complex and that it probably interacts transiently with its partners. Ycf3 contains a number of tetratricopeptide repeats (TPR); TPR is a structural motif present in a wide range of proteins, which mediates protein-protein interactions.
Sources: en.wikipedia.org
The most common method for alkylation of the lactam nitrogen of 2,5-diketopiperazines is based on the use of sodium hydride as base. However epimerisation can occur especially with proline-fused 2,5-diketopiperazines, even with milder methods such as under phase-transfer catalyst conditions for example 1 to 2. Reduction of the carbonyl groups of chiral 2,5-diketopiperazine with lithium aluminium hydride (LiAlH4) cleanly gives the corresponding chiral piperazines. For example, cyclo(L-Phe-L-Phe) 1 gives the chiral piperazine (2S,5S)-dibenzylpiperazine 2. Reaction of the lactam-derived enol phosphates 4 of 2,5-diketopiperazines with palladium catalyzed reactions (reduction, Suzuki and Stille cross-coupling reactions) enables the synthesis of a range of functionalised 1,4-dihydropyrazines 5 which can be aromatized to 1,4-pyrazines 6 in the presence of acid.
Within the field of supramolecular polymerization, Schmatloch et al. used automated synthesis to create main-chain supramolecular coordination polymers, reacting bis(2,2′:6′,2″-terpyridine)-functionalized poly(ethylene oxide) with various metal(II) acetates. From this, it was revealed that classical laboratory approaches could be transferred to automatic synthesis, optimizing the processes to increase efficiency and aid with reproducibility.
ACC synthase reaches optimal activity in conditions of pH 8.5 and with Km = 20 um relative to its substrate, SAM. ACC Synthase and ethylene biosynthesis are regulated by a whole host of stimuli. Stresses such as wounding, noxious chemicals, auxin, flooding, and indole-3-acetic acid (IAA) promote ethylene synthesis, creating a positive feedback cycle with ACC synthase, up-regulating its activity. However, it is also inhibited by a number of compounds as well. S-Adenosylethionine can bind as a substrate for ACC synthase (with higher affinity than SAM) and therefore inhibit any reaction with SAM. ACC Synthase is also competitively inhibited by aminoethoxyvinylglycine (AVG) and aminooxyacetic acid (AOA), inhibitors to many pyridoxal phosphate-mediated enzymic reactions. They are natural toxins that cause slow binding inhibition by interfering with the coenzyme pyridoxal phosphate. ACC synthase activity is also inhibited by intermediates of the activated methyl cycle and the methionine-recycling pathway: 5′-methylthioadenosine, α-keto-γ-methylthiobutyric acid, and S-adenosylhomocysteine.
Sources: en.wikipedia.org
Dividing a stock into single-use portions usually reduces multiple thawing and refreezing events and lowers contamination risk. It also allows a needed amount to be removed without warming the entire supply.
Peptides can adsorb to some plastics and glass, especially at low concentrations, which reduces the measured amount in solution. Low-binding polypropylene tubes limit this loss and improve reproducibility.
Thawing on ice or in a cold water bath is generally preferred over rapid heating, which can accelerate degradation. Once thawed, the aliquot should be kept cold and used promptly rather than refrozen.
Removing water reduces hydrolytic and some oxidative degradation. Powder forms are generally more stable for long-term storage than solutions. Stability still depends on peptide sequence, residual moisture, and container conditions.